Processor power management > Maximum processor state > Setting = 100%.Processor power management > Minimum processor state > Setting = 100%.Display > Turn off display after > Setting (Minutes) = Never.USB settings > USB selective suspend setting > Setting = Disabled.Sleep > Sleep after > Setting (Minutes) = Never.Hard disc > Turn off hard disk after > Setting (Minutes) = Never.In the window that opens make sure you have the following settings: On the next page set both 'Turns off the display' and 'Put the computer to sleep' to Never.Set the Power Scheme to High Performance (if this setting is not available, click on Show additional plans first).Go to Start > Control Panel > System and Security > Power Options.Repeat steps 3-5 for all devices in the Universal Serial Bus Controllers section.Ĭheck the general power management of your computer:.Untick the option: 'Allow the computer to turn off this device to save power'.Right-click each USB Root Hub, and choose Properties > Power Management tab.Find the Universal Serial Bus controllers section (shown in the image below).Open Device Manager (Start > Control Panel > System and Security > System > Device Manager).If you're using a Windows computer, disable power saving mode for USB devices, to do this: Some USB ports perform better than others, particularly rear ports on a desktop system. If your Launchpad cannot connect to your system and the lights stay flashing this means there is an issue with the connection to the computer.įirst, connect your Launchpad to all available USB ports on your system. The first thing to check on any system is that the cable is fully inserted into the Launchpad, it's always worth giving the cable an extra push to ensure this is the case.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |